202DNAR 7 inch 2 DIN Windows CE 6.0 / Windows CE In-Dash Car DVD. As Windows CE 6.0, Sirf Atlas IV 533 MHz 128 Mb, 800x480, GPS Dual Zone). In the process of preparation, an alternative shell, navitel, etc. Add NAVI is covered, when navigating to the navigation mode, the blue screen.

THIS POST IS NOW OUTDATED! The instructions below only apply to kernel version setenv bootargs mxcfb0:dev=hdmi,1280x720M@60,if=RGB24 U-Boot> saveenv U-Boot> run bootcmd Windows CE Windows Embedded Compact 7 from Adeneo contains two support for HDMI and the Freescale LVDS1 panel in the form of two separate O/S images ( NK*.bin). QNX At the time of this writing, only the 7″ Parallel RGB display is supported in QNX. Known issues There is a known bug in the HDMI driver which causes display corruption if an HDMI monitor is either disconnected and reconnected or powered down and back up during operation.

A customer just reminded me of an outstanding bug related to Ubuntu releases and the 7″ display. It appears that something in the startup of X decides to re-configure the display and in the process, bit 17 of the IPU1_DI0_GENERAL register gets cleared to zero. This bit defines the pixel clock polarity and this will result in visible artifacts on the display.

If you see this problem, you can use the ‘devregs’ tool at to verify the symptom and temporarily fix it. Root@linaro-ubuntu-desktop:~# devregs IPU1_DI0_GENERAL IPU1_DI0_GENERAL:0x02640000 =0x00300004 root@linaro-ubuntu-desktop:~# devregs IPU1_DI0_GENERAL 0x00320004 IPU1_DI0_GENERAL:0x02640000 =0x00300004 IPU1_DI0_GENERAL:0x02640000 == 0x00300004.0x00320004 You can read about devregs in this post: And you can get the sources here. Hi Eric, I am trying to install Linux on our custom board similar to the I.MX6Q SabreLite board. I am using linux-imx6-boundary-imx_3.0.35_4.0.0 and linux-imx6-boundary-imx_3.0.35_1.1.1.

On the SabreLite HDMI uses I2C2, and on our custom board HDMI uses I2C3. How to move HDMI from I2C2 to I2C3? I am move I2C_BOARD_INFO(“mxc_hdmi_i2c”, 0x50) from static struct i2c_board_info mxc_i2c1_board_info[] __initdata to static struct i2c_board_info mxc_i2c2_board_info[] __initdata in board_mx6q_sabrelite.c What else it is necessary to make? (excuse for my bad English). During u-boot loading time I see the image on the monitor, and during Linux operating time – no.

I am looking for some video assistance on a custom i.MX6Q board we have in development. Currently I have HDMI and LVDS displays connected. When I boot our Ubuntu Linux kernel, only the video source which is attached to mxcfb0 displays the GUI. I can still utilize both displays using gstreamer. Should I be able to use both displays to extend the Ubuntu GUI? If so is the xorg.conf file used to set this up?

• Launch Viaway App on your device. Please note you can activate Viaway service right on your Android, Apple or Windows device. For others, please read below. To watch Viaway on your entertainment device, please follow these steps to activate your device and let us know if we can assist you further. If you want to.